22" WELD Wheel Offset question

[kacyk]

I bought used 22" Weld Evo Slingblades and am trying to determine the offset. I went on their web site and they indicate two offsets, either 22 or 35. The 22 mm offset is for the H2's. In case I got the wrong offset, what might happen? I'm going with 325/50-22's whish is the same height as the stock tires. I can't see how under 10 mm's will crete any rubbing or?

In fact, I'm sure the DRIV NT-2's I have on now are the wrong offset as they stick out about an inch from the fender lip. I get no rub and besides, I like that look. My only concern is that the higher positive offset will make the wheel tuck under to the point that it rubs.

Please advise.

[tower]

Yes a more positive offset will push the wheels closer to each other.
http://www.raceandroad.com/images/ns-offsetexplained.jpg
And the difference between 22 and 35 is 13 NOT less than 10. It is potentially enough to rub when your wheels are at full lock (especially off-road) in front and to snap off your height sensors if you have air suspension in the rear. I am not saying that this will happen to you because I don't know for sure and there are variations from one truck to the next, but I would procede with extreme caution.