Tie Rod End Grease Seal

[DrG]

After changing my oil, I shot a little grease into the zerts and noticed that I was have a small stream of grease coming out right in the middle of the rubber seal on the passenger side tie rod end. I am not saying it was losing grease at the upper or lower edge as when you overfill it, but this is a tiny hole in the center of the seal. I could reach up there and push on the rubber and more would come out. Is this a leak or is there an overflow valve in these? I didn't see this on the other side and of course, I turned 36000 miles last month too.

[vlxjim]

Not a problem there made to do that your just pushing out the old stuff.

[DrG]

OK, I have seen it push the excess out the top edge and/or bottom edge but haven't ever seen it push it out from the dead center of the rubber resevoir deal there. It is as if there is a hole in the middle of the barrier that holds the grease in place.

[tower]

After changing my oil, I shot a little grease into the zerts and Just FYI, those are ZERK fittings. Zerts are breath mints. :giggling::giggling::giggling:

[IRA51]

sounds like a good time to upgrade to the Fabtec tie rods .

[DrG]

Just FYI, those are ZERK fittings. Zerts are breath mints. :giggling::giggling::giggling:

Thanks for the info. I'll remember to use the Zerts before greasing the zerks.:D

[DrG]

sounds like a good time to upgrade to the Fabtec tie rods .
Sounds like a plan to me.