View Full Version : Wiring for Rear View Camera
My Wife\'s Hummer
02-25-2006, 05:43 PM
I am insalling a rear back-up camera around the license plate. Anyone know the best place to run the wiring? Where should I penetrate into the interior? Do I need to drill a hole?
Please Help!!
Thanks.
My Wife\'s Hummer
02-25-2006, 05:43 PM
I am insalling a rear back-up camera around the license plate. Anyone know the best place to run the wiring? Where should I penetrate into the interior? Do I need to drill a hole?
Please Help!!
Thanks.
Klint
02-25-2006, 07:40 PM
I just cut a small hole in my boot where the rest of the wires are already ran. Just make sure nto to cut any of the other wires!!!
My Wife\'s Hummer
02-25-2006, 07:57 PM
do you mean the boot at the swing gate? i was going to go throug there, but i wasn't able to see where the wires went after that. i poped off a little bit of the trim around the back window, but it looked like the wires were still enclosed in sheet metal.
safari-type61
02-26-2006, 10:41 AM
I had it in this way.
1. I take off a rear lamp (the right).
2. I open a hole to this rubber.
3. I let a cable go through.
4. I drill it with a drill in a storing box of ??the middle.
???Two places of the hole where a cable is ???in and an appearing hole?
5. ??I let you penetrate the hole which ?????opened out with 4. and put a cable through ??rear right seat bottom.
It is the fifth that it is difficult in this.
Thanks.
My Wife\'s Hummer
02-28-2006, 09:19 PM
anyone else do this a differnt way??
thanks
vBulletin v3.0.7, Copyright ©2000-2025, Jelsoft Enterprises Ltd.