Question on install of Headreast monitors

[COREY]

Is there a trick to unhooking the back seat material so I can run the monitor wire through the back of the seat? I have the Vizualogics where the wire goes through the headrest tube.

[COREY]

Is there a trick to unhooking the back seat material so I can run the monitor wire through the back of the seat? I have the Vizualogics where the wire goes through the headrest tube.

[TBarrow]

There is a plastic strip holding the seat cover on. I undid mine and reached up and pulled the cable down. I did not cut a hole I fished it down next to the headrest support.

Black H2 Adventure Series+ all other options.

[COREY]

Thanks for the info TBarrow .....

[RasterMaster]

<BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR>Originally posted by PhilD:
I installed the Vizualogic monitors and used a straightened out coat hanger to feed the wire from the headrest hole down to the bottom corner of the seat. No need to take anything off or apart. To be on the safe side I folded the end of the neger over and covered it in tape, to prevent accidentally damaging the vinyl seat covers.<HR></BLOCKQUOTE>

PhilD,

How did you remove headrests? I picked up the neoprene seat covers which has holes that the headrest "poles" fit into. Any help would be greatly appreciated!

Regards,

RasterMaster

Check out the OkC Chapter Page!

[RasterMaster]

PhilD,

Thanks for your help. DirtyFun was in chat and told me the same thing. Seat Covers went on tight, but I got them on today! Will post pics tomorrow.

Check out the OkC Chapter Page!