Hummer Forums by Elcova
Page 2 of 2 < 1 2
Show 40 posts from this thread on one page

Hummer Forums by Elcova (http://www.elcovaforums.com/forums/index.php)
-   Photos of YOUR H2 (http://www.elcovaforums.com/forums/forumdisplay.php?f=4)
-   -   Hummer steps are on... (http://www.elcovaforums.com/forums/showthread.php?t=36865)

WHOSNEXT 04-14-2009 08:57 PM
Re: Hummer steps are on...
 
Quote:
Originally Posted by Boss Hoss
You can use your stock rocker trim, however the stepping surface will be smaller and i think it looks much nicer with the new trim. You will have to take the stock trim off to get the steps on but your rock rail stays put. When you pull off the stock rocker trim, the clips will break(no way around it) so you will need new clips.

how many clips per side? and does anyone have a part #?

HUMMERICH23 04-14-2009 11:53 PM
Re: Hummer steps are on...
 
Thank you sooo much, that helps me out a lot. You might as well just install the whole kit instead of keeping the stock rocker cover. I see that the colors arent too far off from the textured black stock to the smooth black.

hummer.dad 04-15-2009 04:14 PM
Re: Hummer steps are on...
 
I need the part # for the clips as well. If I have to turn mine back in (from lease) I'm putting the factory rockers back on and selling the steps and side rocker. Need to purchase 24 clips once I have the part #.

tyler1bo 02-27-2011 01:11 AM
Re: Hummer steps are on...
 
Quote:
Originally Posted by hdmlnium
Just wanted to thank Bimmer9938 for the steps and rockers. I put them on this morning and all went smooth. It took me about 2 hours to do the job. They make getting in the Hummer a lot easier now, less wear and tear on the seats as you don't have to slide across to get in anymore.
Anyway, I thought I would add a few pics..
Bill
Love the way that looks! If I hadn't had gone with my AMP's I would've definitely done this.

bigmikey82 08-20-2011 10:03 PM
Re: Hummer steps are on...
 
For those needing the retaining clip part # it is 10297370. I just did mine, but didn't need to buy any clips. I was able to remove the original rocker molding without breaking any clips and they just swap right over to the new rockers.


All times are GMT +1. The time now is 03:45 PM.
Page 2 of 2 < 1 2
Show 40 posts from this thread on one page

Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.