Re: H2 160K Overhaul
 

Fixed it today, it was a bad starter. This were some weird symptoms...

Re: H2 160K Overhaul
 

so is this whole overhaul finally done? is the truck running good now?

Re: H2 160K Overhaul
 

Hahahahaha!!!!
Instrument cluster is completely out and throttle position sensor is almost out.

Re: H2 160K Overhaul
 

bringing up this great thread!

Re: H2 160K Overhaul
 

I would say your a Hummer GOD...but I see you have a Land Rover..so you have alot of experience on rebuilding trucks!

I restored a 1967 88" Land Rover and learned alot from it.

Re: H2 160K Overhaul
 

wow...what a great rebuild thread. its a great feeling when you fix old worn out parts. the creidit card bill hurts, but its a great feeling when old rusted worn down parts get tossed out. hopefully i wont have to do this to my hummer for a while, but im in the stages of doing some of these upgrades to my silverado 2500 with 264K on it.

Re: H2 160K Overhaul
 

72 88" i just finished for my wife, galv frame and all.

Re: H2 160K Overhaul
 

2k hurt lot less them 6.

Re: H2 160K Overhaul
 

220k update.
All the restored parts are doing fine minus the boot on that one half shaft. $500 ebay compressor that we changed at 150~K is dead again but i think that was a good run.

New list.....
Rear door locks not working
Change instrument cluster
Extend rock slides
Drop steps
On star fuse
Day time running lights
Fix no start
Repaint the front end
Rear air fix

Re: H2 160K Overhaul
 

Compressor is out debating between fixing the motor.... $150 or dual stage unit $1,000.

Re: H2 160K Overhaul
 

Blown relay, door locks fixed.


Also replaced the instrument cluster, looks same. Pulled the fuse for onstar and wired up the day time running lights.

Re: H2 160K Overhaul
 

And I felt good after a complete front end suspension rebuild. Good God......

Nice work

Re: H2 160K Overhaul
 

That's quite a job, this forum has changed so much ever since I started lurking around years back. Used to be stereo and rims upgrades top to bottom, now it's a proper Tech section. Love it! :D

Re: H2 160K Overhaul
 

ECM came in today, I'll install it after dinner, make my wife perform a half an hour long introductions, lol.

Re: H2 160K Overhaul
 

Re: H2 160K Overhaul
 

Sandblasted the bumper today and attacked the rust on the crossmember.

Re: H2 160K Overhaul
 

New paint.

Re: H2 160K Overhaul
 

How are you removing the chrome on that grill? How big of a pain is it?

Re: H2 160K Overhaul
 

i removed all the chrome off of mine with a power washer.

total time i think maybe an hour. from there i went and had it LineX

not sure what he did for his

Re: H2 160K Overhaul
 

Is that por15 your putting on the rusted crossmember? Brush on by the looks as well?

I need to get something and start getting the rusted knicks on my frame where something wiped the wax off the frame