|
Check it out.... This is the hardware!!!
http://www.go2pac.com/products/oem1.htm#c2agm24 This is an email I got back from them when I inquired about when they'd be shipping. <BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR>We are starting production next week so I expect them in stock 6-25-03. Place your order with us to insure you get one when they are ready. Brett D. Riggs Pacific Accessory Corporation Santa Ana, CA 92705 800-854-3133 <HR></BLOCKQUOTE> |
Check it out.... This is the hardware!!!
http://www.go2pac.com/products/oem1.htm#c2agm24 This is an email I got back from them when I inquired about when they'd be shipping. <BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR>We are starting production next week so I expect them in stock 6-25-03. Place your order with us to insure you get one when they are ready. Brett D. Riggs Pacific Accessory Corporation Santa Ana, CA 92705 800-854-3133 <HR></BLOCKQUOTE> |
Thank you VERY much NSXer. I am placing my order right now!
wahooooooo Cheers |
NSXer: Would one of these interfaces give my aftermarket amp/system the ability to continue playing after the ignition key was removed ? My stereo installer does not know how to maintain this ability after installing the aftermarket amp behind the factory amp ....any help you can provide would be great.
As of now, the only speakers that remain playing are the two in the rear of the vehicle...used primarily for Onstar. They are the only ones still powered purely from the factory amp. |
pewterpower--> I'm not sure... you say that the only speakers that still work are the ones still connected to the factory amp??? If so, then it appears it may help becuase it would send out the "remote power on feed, and signal" as long as the factory system is still powered...
|
I think that's the issue....determining the power-feed for the factory amp. My installer says that he cannot locate one.....says this system is just like the one in some Cadillacs.
Because the power feed for my aftermarket amp is not the same source as the factory system....I lose that when I turn off the ignition. I don't want to direct-wire it and be responsible to turn it off each time but would like to enjoy the feature where it stays on until the doors are opened if possible..... Any suggestions on where I might go to investigate this further ? Maybe the dealer ? |
pewterpower--> This device does exactly what you want. It provides a remote turn on feed for your amps. Basicly, your amps should have a heavy gauge power feed like 8 or 10 gauge that goes directly to the battery or main power block, then you utilize the remote feed from the PAC device to switch the amps on and off. Just like any other aftermarket headunit/amplifier setup.
cool! |
Any clue on Price???
|
Albie--> should cost around $140.00. I talked to my distributor in Florida and that's what he said. btw... you have to order through a local dealer. for me it's rollin sound here in Jacksonville. They then place the order with Audio America, which in turn places it in a back order que........... So I should have mine in about 3 years!! he he he....
|
NSXer, I called one of the distributors on the PAC web site, and got the same story, then I called another one (in Paramus NJ) and they told me they will sell direct. I do not want to wait 3 years to get my interface either!
 I will be calling all of them after I find out that PAC has started to deliver the product. I will keep you all informed Cheers |
wannabeinit--> Let me know wat you find out bro! Whenever you get someone to say they'll ship it, order me one too!!! (or give me the number to the place and I'll order) Maybe we can get a deal if we all order!!
If you like bikes... Check out http://www.usualsuspex.com |
<BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR> We are starting production next week so I expect them in stock 6-25-03. Place your order with us to insure you get one when they are ready.
Brett D. Riggs Pacific Accessory Corporation Santa Ana, CA 92705 800-854-3133 <HR></BLOCKQUOTE> great.... that date has come and gone with no "new" info! They don't want us to have it!!!!! Mother Biatches!!! If you like bikes... Check out http://www.usualsuspex.com |
NSXer
I just talked to PAC on the phone today. They had a minor delay. She said she would not give another estimate because they missed there previous estimate. However she said it will be ready soon. She is going to call me when it is ready. I will let you all know when she calls. Cheers |
|
I called her Friday and she said it was in testing. And to call back next week.
Cheers [ formerly known as wannabe and wannabeinit ] |
very interested aswell, please let me know
|
Doesn't solve the aux input issue!
|
|
|
I should have news for everyone on Wednesday about the PAC H2 interface.
Cheers [ formerly known as wannabe and wannabeinit ] |
they are in!!!!!!!!!!!!!!!!!!!!!!!!!! I just ordered mine!! I should have it in a few days. I'll let everyone know how good it works. yipee!!! I only had to wait 3 months, not three years!
If you like bikes... Check out http://www.usualsuspex.com |
A lot of us are anxious to hear about this!
-Randall Garrett- |
about freaken time..... How much?
|
just under $90.00! If it works like it is supposed to, then it'll be well worth it!! I'll let you guys know! I'm set up as a "dealer" so if you guys want I'll order a bunch, them ship them to you guy, but I'd rather wait until after I test it out so I don't have to worry about returns and the like!
If you like bikes... Check out http://www.usualsuspex.com |
NSXer
It is about time. Now I will not have to turn my amp off manually any more.  Mine is coming overnight, so I should have it installed tomorrow. I will let you all know how it goes. I purchased mine through a dealer/distributor that will ship to end users. They are $75 plus shipping. Ask for Scott at HP Distributing, 310 324-5301. He was great to deal with and they have them in stock. Cheers [ formerly known as wannabe and wannabeinit ] |
Looking forward to hearing how the interface is. Ease of installation, quality, etc. I have 2 10" Polk Subs in bandpass box just itching to get into my H2. Keep us posted!
03 Black Adventure with all Lux Options,Brush Guard Lights, and Sylvania Silverstars. Go Vols!!! |
My C2A-GM24 arrived today as promised. However, it does not function!
  I spent time with the PAC tech-support on the phone and they said it must be defective. They want me to send it back before they will send me another unit. HP Distributing was no help as they said they can not get more of them for two weeks and the four they had sold instantly (one was to me). Sooooo MSXer, it is up to you to tell us how it works. Some of the interesting things that the install guide said is that you can have the unit adjust the volume based on the fade setting on the factory head unit. Also, if you turn the volume all the way down it will shut off the remote amp circuit. It said nothing about the tone controls on the radio so I do not know if they effect the output of the interface or not, I suspect not. Cheers [ formerly known as wannabe and wannabeinit ] |
I hope mine freaking works!!! I won't know till tuesday though, because I just had them ship it ground. I'll let you guys know ASAP!
If you like bikes... Check out http://www.usualsuspex.com |
it's here!!!! I'll install tonight and let you guys know!
If you like bikes... Check out http://www.usualsuspex.com |
Karl at PAC received my unit back today. He tested it and said it works fine in his diagnostic test setup!
I said "oh don't tell me that" Anyway, he is sending me out another brand new unit. It will go out UPS ground, I should have it next week. Until then . . . Cheers [ formerly known as wannabe and wannabeinit ] |
I just got off the phone with Karl at PAC and he explained to me that I can not read!
 The instructions say to plug the PAC interface into the factory head unit. I plugged it into the bose amplifier (the plug is the same on both ends) and it does not work there. That is really too bad because it would be so much easier to plug it into the amp. Oh well! Alls well that ends well. Cheers [ formerly known as wannabe and wannabeinit ] |
NSXer
Was it you that they were working with when they figured out what I was doing wrong? Karl said another tech was working with a person who knew of my postings. Cheers [ formerly known as wannabe and wannabeinit ] |
it was me!!! I hooked it up at the amp and..... it didn't work, so i figured I'd call them and see if I could figure out what was up.... Well, it has to be connected at the head unit even though the connectors are the same. I told him you most likely did the same thing i did. It's hooked up now and it works great!! I love it! The device does exaclty what it says it'll do! The fade function is really useful. Cheers!! Everyone needs to order up!
btw.... let me know when you go to install. I'm now an expert on removal/installation of the stock components. NICE!!!!! If you like bikes... Check out http://www.usualsuspex.com |
NSXeR, tell us what exactly this unit does! Thanks i look forward to hearing from you on this.
|
dude it freakin rocks! It goes inline with your existing bose system. It does not hinder your stock system at all, but what it does give you is: the ability to hook up an aftermarket amplifier. The big difference between it and other "converters" is that it does it before the bose amplifier! That way you get a clean, unprocessed signal. I hooked it up to my Kenwood 500Watt amp and 2 JL 12" subs. It is perfect for adding deep bass to the stock system.
If you like bikes... Check out http://www.usualsuspex.com |
How hard is the install? and Do you know if we can use the coming Aux input device from PAC while using the Amp add on device from PAC? Thanks!
03 Black Adventure with all Lux Options,Brush Guard Lights, and Sylvania Silverstars. Go Vols!!! |
Did Rollin sound do your install? if so, would you use them again?
|
no. i did it myself.... and I would use myself again! ha!
TN--> the install was not bad, just time consuming. It took about three hours to run all the cables for the amps, install the PAC, etc. but, it was well worth it. awesome results with the complete stock look! and I'm not sure about the aux input box. I hope it does, becuase I have XM and DVD that right now are RF modulated. I can't wait to have a clean input. we'll see. If you like bikes... Check out http://www.usualsuspex.com |
would you have any pics of your work?
|
One more question I thought of. Does the interface have a line level to RCA output converter or will I need to buy one so I can run my inputs to the aftermarket amp. Ditto on the pics!!! That would be really great! Thanks
03 Black Adventure with all Lux Options,Brush Guard Lights, and Sylvania Silverstars. Go Vols!!! |
| All times are GMT +1. The time now is 12:11 AM. |
Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.