Need parts information please...
 

You all have been super in helping me find information and hoping you can help again.

Since buying my H2 I have had 4 back surgeries and have had to "retire" and live on a small fixed income. So now that my truck is 12 years old, there are some parts I need to replace and can't afford new. I am hoping that not only can you advise me in finding used but in some of the technical names. Lol. I just figured out that one of the parts is called a "cornering light". Lol

Anyway, parts needed:

Front Passenger side cornering light.

Rear door/hatch/cargo handle door and cables. (Right now rear cargo door won't open at all)

The rear passenger door lock. The single little piece that has the tab that slides lock-unlock. The tab broke off.

Any help would be GREATLY appreciated.

Thanks all

Sheila

Re: Need parts information please...
 

That sucks about the back. I've had back surgery myself and am currently in a bad spot so I feel your pain....literally!

Front passenger side cornering light, are you talking about the front amber blinker next to the headlight or the side marker? I'm going to assume the side marker as those can go out, the front blinker is just a bulb replacement. Side marker is a sealed unit, you'd have to replace the entire unit. They run around $100 each.

http://www.ebay.com/itm/03-09-Hummer...RWxdQE&vxp=mtr

Amber side markers are much easier to find then the rear red markers.

The rear hatch should just need the actuator, I'd be surprised if you need to replace the cables. Same thing happened to me.

http://www.ebay.com/itm/For-Yukon-Su...dVQJwe&vxp=mtr

I can't find the exact one I purchased but that one should work, double check the part number to be safe.

The door lock trim piece will be a little difficult to find. If it is something you can super glue I personally would go that route.

http://www.ebay.com/itm/Chrome-Bille...RSW2Kw&vxp=mtr

That is a chrome billet part and I'm sure a hell of a lot cheaper than a full OEM replacement. Could always scuff and spray paint it black. I didn't see any OEM parts from a quick search.

Hope all that helps and I hope your back starts feeling better. I just ordered an inversion table as recommended by the doctors I work with and the PA who saw me in office. I am very optimistic and can't wait for it to get here!

Re: Need parts information please...
 

Thank you so much for the information. I'll get on it today.

Good luck with the table. Sadly to late for me for that. Scar tissue has encroached on nerves causing issues. But prayers are with you it works!

Sheila

Re: Need parts information please...
 

No worries, hope you start feeling better!