Let me start with a disclamer, "I am not an idio!!" O'K, now that we have that out of the way. I am trying to get to my front turn signals and marker lights, but am having difficulty. Has anyone done this yet? I am going to wire the side markers to blink with the turn signals, but I can't seem to find a way to them. Do you have to completely remove the wheel shroud? Thanks!!
By the way, does anyone else think the side markers should blink with the turn signals??

Let me start with a disclamer, "I am not an idio!!" O'K, now that we have that out of the way. I am trying to get to my front turn signals and marker lights, but am having difficulty. Has anyone done this yet? I am going to wire the side markers to blink with the turn signals, but I can't seem to find a way to them. Do you have to completely remove the wheel shroud? Thanks!!
By the way, does anyone else think the side markers should blink with the turn signals??

Sounds very cool to me, let me know when you figure it out! I would like to do the same!

According to the service manual, you have to remove the wheelhouse panel to access the side marker and the front turn signals.
Just a note to remind you that if you add some more bulbs into the turn signal circuit, the flasher may operate slower, since the turn signals are controlled by the BCM. Let us know what happens, I'm curious.

what is the wheel house panel. I would like to try this.

I believe f5fstop are talking about the inner plastic part that covers the wheel well.