I really like the nitto mud grapplers. I searched all over the forum for a pic with the stock wheels and had no luck. Any body running these on the stockers?

I really like the nitto mud grapplers. I searched all over the forum for a pic with the stock wheels and had no luck. Any body running these on the stockers?

242

sorry, not me.

I guess this is a ****ty combo since nobody is running it.

prolly would look cool, just nobody has seen it or has pics of it, i love my nitto grapps, but i got 18 inch motomeatls , be the first one to run grapps on stock, go for it

I had Nitto MG's on my 03. At that time they did not make a 17".

I now have toyo 37 x 13.5 x 17, on stock wheels, with cranking the torsion bars they fit well. Except the rear which used to hit the frame and the airbag sensors (I was told that the coil springs would actually rub on the tire) I had to switch the arm of the air bag sensor to the inside, which stopped the problem of broken sensors at each ditch I crossed. The Nitto's should be a little worse due to the large side lugs. If you use an aftermarket rim with 4.5" offset it will definetly rub in the front when turniing. Good luck.

Here are some pics of something i posted earlier:
http://elcova.com/groupee/forums/a/tpc/f/6706011751/m/3...501057351#6501057351