I'm getting ready to replace my plastic valance with the SMA valance to further strengthen the SMA HD Brushguard.

For those that have installed the PIAA 520's inside the valance, how did you wire them in? Did you wire them into the exiting daytime running light wires, or?

Thanks so much!

-Justyn

[This message was edited by SOCRATES on 03-22-04 at 08:59 PM.]

I'm getting ready to replace my plastic valance with the SMA valance to further strengthen the SMA HD Brushguard.

For those that have installed the PIAA 520's inside the valance, how did you wire them in? Did you wire them into the exiting daytime running light wires, or?

Thanks so much!

-Justyn

[This message was edited by SOCRATES on 03-22-04 at 08:59 PM.]

I'm getting ready to replace my plastic valance with the SMA valance to further strengthen the SMA HD Brushguard.

For those that have installed the PIAA 520's inside the valance, how did you wire them in? Did you wire them into the exiting daytime running light wires, or?

Thanks so much!

-Justyn

[This message was edited by SOCRATES on 03-22-04 at 08:59 PM.]

I did not hook the DRL's back up. You have 3 basic options:

1. Hook them up to a seperate switch
2. Hook them up to come on with your low beams
3. Hook them up to come on with the high beams

Number 2 and 3 will require a relay to set up. Nice and easy. You can use either the low or high beam wire to trigger the relay, depending on which setup you want.

Thanks, Mike..

I'm leaning toward using the switch because it came with one and I'm lazy.

Cheers,
-Justyn