Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

Did they route the exhaust or air intake differently?

Were there different parts installed?, or was it a software thing.

Thanks

Finbox

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

Tow/haul button?:giggling:

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

:D

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

Ball and roller bearings dont provide enough resistance to the flow of oil to keep the pressure up. Besides, that would only reduce friction, not increase power.

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

HP in PCM was turned up just like handhelds do. They could turn it up to about 425HP easily give or take some depending on if they helped with exhaust adjustments from factory. They have warranty to think about as things would most likely break more off road. That is why I do not recommend superchargers for off road. Over powering in certain conditions breaks things allot more easily.

You can get laptop tuning software and make it do even more than a handheld can do. If You setup a wideband sensor You get real time reading while tuning. You can buy the basic tune and see all kind of stuff in real time if Your into that. It takes some learning but plugs into OBD2 port and Your set. There are many things You can adjust that has nothing to do with tuning or engine.

TAZ

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

Linus I think DRTYFN was kidding =)

--John

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

I thought about that after I posted and saw that he quoted someone, and that quote wasn't from this thread. I'm sure he is thick enough skinned not to take offense.

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

Oh, he's thick headed alright...


opps, you said thick skinned... my bad.

:D

Mark

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

Quoted someone?? Are you kidding?? Have you never seen Fletch?? :giggling:

You Should be banned just for that comment!

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

You noticed that too? You should see it in person.:giggling:


:jump::jump::jump::jump:

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

I knew there'd be someone that got the quote.:clapping: There's some of the greatest lines in that movie.:jump:

:jump:

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

Quote:
*knock knock knock*
"Who is it?"
"...John..... Cock...toasten..."

John Cock Toasen LMFAO!! :jump: :jump:

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

John

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

Cocktoasten

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

:excited: :excited: :excited: :excited: :excited: :excited: :excited: :excited: :excited: :excited:

Re: Horsepower was increased from 316 to 325 in 2005, how did they do it?
 

Reducing friction will also increase power...less power to turn the rotating assembly means more makes it to the crank.

"I'ts Scotch-Romanian."
- "That's an odd combination."
"You should see my parents."