Hummer Forums by Elcova

Hummer Forums by Elcova (http://www.elcovaforums.com/forums/index.php)
-   General H2 Discussion (http://www.elcovaforums.com/forums/forumdisplay.php?f=6)
-   -   WINCH FOR H2 (http://www.elcovaforums.com/forums/showthread.php?t=21686)

WHOSNEXT 10-28-2006 02:27 AM

WINCH FOR H2
 
I'm starting to look for a winch for my truck and was wondering what you guys are doing with your front plates? i know some states dont require them but my state does.

DennisAJC 10-28-2006 05:50 AM

Re: WINCH FOR H2
 
Velcro.

OrangeCrush 10-28-2006 01:25 PM

Re: WINCH FOR H2
 
Being from NC we don't have front plates. If we did however, I would have just moved my plate to the passenger side and mounted on the front of the bumper. I think it would have looked cleaner there than try to have it "hang" under the bumper out of the way. (nevermind the potential to get ripped off when you hit the curbs at the mall) :D


Mark

Vettster 10-28-2006 04:42 PM

Suction Cups!
 
I took mine and fastened some suction cups to the 4 holes onthe plate.
I just stick it to the inside of the windshield.

dallas007 10-31-2006 03:51 AM

Re: WINCH FOR H2
 
I put mine on the drivers side on the bumber. I used a hinge and mounted one side of the hinge on the bumber and the other to the plate. Then if I needed to use the tow ring, the plate would swing up and expose the tow ring and make it useable. I have had my H3 for three years and never used that ring yet.

KenP 10-31-2006 04:27 AM

Re: WINCH FOR H2
 
I usually don't use the required front plate. It's on the floor in the back. If I get pulled I'll just tell the officer the bumper is new and I haven't figured out where to mount it, yet.

I did have it on for a few month, however, using velcro to hold it on. I took a couple of screws and cut the heads off and clued them to the plate so it looked as if the plate was screwed on. It passed inspection this way.:shhh:

tomp 11-07-2006 04:58 PM

Re: WINCH FOR H2
 
1 Attachment(s)
Use two sets of Maglite D-Cell flashlight holders and attach them to the back of the OEM front license plate holder. Snap the assembly onto the roller fairlead of the winch. See pics...

tomp 11-07-2006 04:58 PM

Re: WINCH FOR H2
 
1 Attachment(s)
pic 2

tomp 11-07-2006 04:59 PM

Re: WINCH FOR H2
 
1 Attachment(s)
pic 3

ipeefreely 11-07-2006 05:38 PM

Re: WINCH FOR H2
 
NEAT-O :beerchug:

ROX 11-08-2006 03:30 AM

Re: WINCH FOR H2
 
Quote:

Originally Posted by tomp
Use two sets of Maglite D-Cell flashlight holders and attach them to the back of the OEM front license plate holder. Snap the assembly onto the roller fairlead of the winch. See pics...

smarty pants....;) :D


All times are GMT +1. The time now is 06:03 AM.

Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.