Hummer Forums by Elcova

Hummer Forums by Elcova (http://www.elcovaforums.com/forums/index.php)
-   Technical Discussion and Customizing your H2 (http://www.elcovaforums.com/forums/forumdisplay.php?f=5)
-   -   lube question (http://www.elcovaforums.com/forums/showthread.php?t=22583)

rusty 11-28-2006 09:42 PM

lube question
 

has anyone been able to lube the top nipple(not the one on the arm) in this pict without removing the skidplate??

mdoyle 11-29-2006 12:00 AM

Re: lube question
 
You can buy a 90? Zerk to make the job a little easier, also turning the wheel fully to one side sometimes provides clearance.

H2bill 11-30-2006 02:01 PM

Re: lube question
 
Quote:

Originally Posted by PhilD
There was a TSB on this and if I recall dealers were supposed to replace the fitting with a 90* one as and when they lubed it. But I've not heard of that happening much.

You can get a side mount nozzle for your grease gun, or as suggested just change it out for a 90*, it is really easy to do.


Meaning, you just unscrew the one in there and replace with a 90? Do you know off hand what size it is?

Adam in CO 11-30-2006 04:57 PM

Re: lube question
 
Oops, wrong thread. I saw "lube" and "nipple" and figured it was the woodshed.

CO Hummer 11-30-2006 05:03 PM

Re: lube question
 
Quote:

Originally Posted by PhilD
Yes.

Can't recall, but pretty sure it is metric, so 6 or 8mm. Just take the existing one out and take it to the store with you.



The zerk fittings are the 1/4" size.

I replaced mine about 5 minutes. I like these 90 degrees valves so much that I also changed a couple of the lube ports on my Suburban too.

I can reach that valve with my skid plate ON. However, I have an H2Oguy aftermarket skid plate. In any case, you need a grease gun with at least an 18" hose.


All times are GMT +1. The time now is 04:15 PM.

Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.