![]() |
Front End Problems
Ok Guys I need Help
Problem: Slight shimmy in my steering wheel from 50mph on up. Along with that I feel like I have a tire out of balance or a huge rock stuck in my tire as I get a hammering that I can feel in the floor of my truck when over 50mph. The Hammering and Shimmy occur with every rotation. When backing out of a parking spot and turning the wheel I get a single Pop/Clunk Sound as well. Truck Status: 71K Miles on it. 18 Inch Wheels with 37 Inch BFG K/M's----Recently Balanced with DynaBeads New Idler Arm New Passenger Side Hub I think the T-Bars are cranked--Done before I got it. Also I have shook the front end down thinking maybe my drivers hub was bad but it is showing no signs. Ball Joints and Tie rods are all good. My guess: I was thinking steering shaft but that would not give me a shimmy/Hammering with every rotation of the wheel. So I am leaning toward a bad CV Shaft? No quiet sure. Maybe Humtech would know? Any help would be great guys. Thanks, Eric |
Re: Front End Problems
sounds like a bad CV joint in the front. if its a "cachunk cachunk" type sound while backing with the wheels turned then I would say most likely. if its the same going each way then it could be a wheel bearing. do you have times where your brake pedal is low? that would mean its a bad bearing and opening up the caliper.
|
Re: Front End Problems
Yetti,
Thanks for the response. I have no brake broblems at all. I Olny get a single clunk when I turn the wheel. |
All times are GMT +1. The time now is 05:14 PM. |
Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.