Hummer Forums by Elcova

Hummer Forums by Elcova (http://www.elcovaforums.com/forums/index.php)
-   Technical Discussion and Customizing your H2 (http://www.elcovaforums.com/forums/forumdisplay.php?f=5)
-   -   Replacing front CV Half Shaft Assembly (http://www.elcovaforums.com/forums/showthread.php?t=34480)

DrG 06-16-2008 04:10 AM

Replacing front CV Half Shaft Assembly
 
Has anyone every replaced a front CV Half Shaft Assembly? I poked a hole in one of the boots when I broke a tierod and a entire half shaft from RockAuto is as cheap as a new boot from GM. It looks easy enough but is it??

Also, what service manual describes this kind of stuff best? The factory manual??
David

RuggedH2 06-17-2008 03:30 PM

Re: Replacing front CV Half Shaft Assembly
 
I carry a spare in my rig when I wheel. I haven't had to use it yet, but I downloaded the directions for install and it is easy. It could be done on the trail with the right tools....... you will need a 35 mm socket and a breaker bar.

DrG 06-17-2008 10:37 PM

Re: Replacing front CV Half Shaft Assembly
 
The procedure looks to be pretty straight forward. My regular mechanic had priced the labor at $200 and the axle at $150. That much of a labor charge made me think the axle was pressed into the wheel and was going to require a lot of work. After checking it out, I just don't see it being that tough unless the spline hangs up in the wheel. I picked up a new half shaft with a lifetime guarantee at O'Reillys for $60 plus a core charge that I'll get back. I think I have over-thought this one and made it more difficult than it's really going to be. I'll let you know after I do it this Saturday.

PaHumBug 10-14-2010 08:50 PM

Re: Replacing front CV Half Shaft Assembly
 
Hey guys, the stealership just told me that my axle seal on the front diff is leaking, and the "axle spacer" on the opposite side is broken (I have a 6 inch fabtech lift so the spacer isn't stock). How hard is it to change those seals and the spacer? Is it just a matter of taking some bolts out and pushing that end of the axle aside? Or will the whole front end need torn apart?
Thanks

Hellz 10-14-2010 09:05 PM

Re: Replacing front CV Half Shaft Assembly
 
holy thread hijack!!!
let alone raising the dead..

PaHumBug 10-14-2010 09:19 PM

Re: Replacing front CV Half Shaft Assembly
 
Yeah sorry for the highjack but this was the closest thread I could find in searching for my problem and figured you guys would know. In the future should I just start a new thread?

Hummerguy32 10-15-2010 02:54 PM

Re: Replacing front CV Half Shaft Assembly
 
Quote:

Originally Posted by PaHumBug
Yeah sorry for the highjack but this was the closest thread I could find in searching for my problem and figured you guys would know. In the future should I just start a new thread?


Ya Think :lame:

PaHumBug 10-15-2010 03:00 PM

Re: Replacing front CV Half Shaft Assembly
 
Sorry I'm new to forums. I've been on this one for years but don't always come here unless I have questions and usually just find my answers by searching. I will start a new thread. My bad.


All times are GMT +1. The time now is 06:56 PM.

Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.