I am insalling a rear back-up camera around the license plate. Anyone know the best place to run the wiring? Where should I penetrate into the interior? Do I need to drill a hole?

Please Help!!

Thanks.

I am insalling a rear back-up camera around the license plate. Anyone know the best place to run the wiring? Where should I penetrate into the interior? Do I need to drill a hole?

Please Help!!

Thanks.

I just cut a small hole in my boot where the rest of the wires are already ran. Just make sure nto to cut any of the other wires!!!

do you mean the boot at the swing gate? i was going to go throug there, but i wasn't able to see where the wires went after that. i poped off a little bit of the trim around the back window, but it looked like the wires were still enclosed in sheet metal.

I had it in this way.

1. I take off a rear lamp (the right).
2. I open a hole to this rubber.
3. I let a cable go through.
4. I drill it with a drill in a storing box of ??the middle.
???Two places of the hole where a cable is ???in and an appearing hole?
5. ??I let you penetrate the hole which ?????opened out with 4. and put a cable through ??rear right seat bottom.

It is the fifth that it is difficult in this.
Thanks.

anyone else do this a differnt way??

thanks