removing the center shift console?
 

Is there a way to remove the center shift console on a 03 H2?

I need to take it out as much as possible to pull up the padding underneath and replace it

Thanks for any help

Re: removing the center shift console?
 

Re: removing the center shift console?
 

Just don't forget the fastener of the front side of the gear shift. I had a heck of a time figuring out how to take it off until I saw there was an allen wrench type screw in the front, hidden against the center console with the shift lever full forward in Park.

Re: removing the center shift console?
 

Its a t-15 torx bit in the shifter handle

Re: removing the center shift console?
 

Thanks guys.
That will be my tomorrow project.
I need to order the mat and possibly the carpet since it smells wet still in my truck.

I need to pull up and out the carpet since I ripped the sponge that is known as the padding out.

I would have done that today but the time wasnt there after I worked on the Vette and then the biting gnats started getting to me since it was after 430p.
Ugh!

Anyways, The positive spin is I can do some wiring for my fire dept flashers and also pre-wire in an amp setup to give the stereo just a little bit more ooomph.

Thanks for the info!!

Re: removing the center shift console?
 

fyi, if you lose or break any of those clips from the above link, which no matter how hard I tried not to, I lost one very time,,, you can get them at you local GM dealer for like 89 cents each...

Re: removing the center shift console?
 

Thanks.
Yeah I am getting ready for the re-install this weekend.
The truck is dry, the carpet is clean, getting some new padding from the local carpet store and then I should have everything fine, plus I will have adding in a subwoofer

:-p