What is the gauge of the pin? I am redrilling my accessories that will ride up front, and I think I'll need a bigger bit.

CO H2 Club Rocks!
aps101374@yahoo.com

What is the gauge of the pin? I am redrilling my accessories that will ride up front, and I think I'll need a bigger bit.

CO H2 Club Rocks!
aps101374@yahoo.com

I pretty sure it's a 5/8" if it's standard!

"FORUM FOUNDING MEMBER 11/03/02 - #1 H2 SITE"

It is just a standard pin, you can get a long one from the dealer.

Thanks. I have a pin. I need a titanium drill bit to drill vertical holes in my accessories that are designed for a horizontal one.

<BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR>Originally posted by BADRAP:
It is just a standard pin, you can get a long one from the dealer.<HR></BLOCKQUOTE>

CO H2 Club Rocks!
aps101374@yahoo.com

Sorry missed that question, was typing to fast and not reading...hahaha

03 H2, Lux, Pewter, more upgrades soon..
Houston Texas Hummer H2 Chapter coming soon..

Adam u might want to go to 41/64" drill for the extra 1/64 clearance.
u can put the stuff in rear receiver sideways so u have a guide to keep hole on center.

I found out the hard way that mud does wonders to a locking hitch pin as well. It took the plastic cap off as well.