HERE THEY ARE

Very nice! How does it handle? at HWY speeds? When going around corners does it lean more than stock or feel tippy? How is the overall ride compared to stock? Any more pics of the susp. components installed?

LOVE IT! more pics, more pics, more pics.

LOOKS AWESOME!

As to how does it rides. Suprising enough it feels more stable than stock at slow speeds 0-45mph. Corners are great. Does not feel tippy. As far as 55 and above it just changes lanes quicker but still very stable. Here in florida we have speed limits up to 70mph. At
85(wich is what the speedo read still uncalibrated for new tires) that was about as fast as i wanted to go.

Looks awesome. Thanks for the pix

Because of a ticket? or because of being unstable in some way? 75mph to 80mph is common for me when going to CO Springs from Denver, so this is why I am asking again... just to double check. Sorry for all the Q's.

looks great.....
urs handles relatively good because u went with 20" rims, and u dont have a whole lot of sidewall...so less sidewall flex.
i have a few pics posted.....

HUGE HUGE HUGE!

Looks nice! Rubbin' racin'

What is the pic of that gave you more bottom end response?

I installed throttle body spacer. Forgot to show it installed. beware tougher than instructions. This is not a Colorado and instructions do not adress h3 aplication. Remove all 4 inch ducts. Then remove abs plenum ( two bolts on r side ) Make shure to place new gasket on oposite side of factory green gasket so that there is a gasket on both sides of spacer. Finally make shure to reinstall small hose on bottom of abs plenum befor reinstalling the ducts. P.S. This may be a little difficult due to the new throttle bod spacer. I solved this by applying a small dab of vasoline on male end of ducts to allow them to slide in easier. Dont laugh it worked.

hey!
where did u get the spacer kit? can u post a link?

is this it??
http://www.gstyle4u.com/.sc/ms/dd/H3%20Performance--H3%...202006%20HUMMER%20H3

How long to install?

Sweeeet!

Dang. Double dang. That ride rocks.

How long did you drive it before installing the throttle body spacer? Are you going to install the airaid intake kit?

Serious bling with an offroad slant. Great pics.

S.

Sweet.
love the color.

Man, that took you 6 hours? The yellow doesn't do much for me but your rig looks good!!! 6 Hours? That's a good case in the OR... Guess, I'll have to hire somebody if I want one somedays. Thanks for the pics.