Hummer Forums by Elcova  
Forums - Home
Source Decals

Source Motors
Custom. Accessories.

H2 Accessories
H3 Accessories
Other Vehicles

H2 Source

H2 Member Photos
H2 Owners Map
H2 Classifieds
H2 Photo Gallery
SUT Photo Gallery
H2 Details

H2 Club

Chapters
Application

H3 Source

H3 Member Photos
H3 Classifieds
H3 Photo Gallery
H3 Owners Map
H3 Details
H3T Concept

H1 Source

H1 Member Photos
H1 Classifieds
H1 Photo Gallery
H1 Details

General Info

Hummer Dealers
Contact
Advertise

Sponsored Ads










 


Source Motors - custom. accessories.


Go Back   Hummer Forums by Elcova > Search Forums

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: Agentorange
Forum: Technical Discussion and Customizing your H2 08-13-2012, 02:29 AM
Replies: 9
Views: 14,852
Posted By Agentorange
Re: Oil Pressure Gauge Pegged to 80

Yes it was definitely bad. Just to be sure, I removed and re-installed the connector before I swapped it out and sure enough, it was still pegged at 80. The connector was a bit of a bear to pop off...
Forum: Technical Discussion and Customizing your H2 08-12-2012, 04:27 AM
Replies: 9
Views: 14,852
Posted By Agentorange
Re: Oil Pressure Gauge Pegged to 80

Its definitely the Oil Pressure Sensor. Had the same issue a few months ago on my 06 H2. Took about 30 minutes.

Its located on the top side if the back of the engine, between the firewall and the...
Forum: General H2 Discussion 06-19-2012, 12:36 AM
Replies: 17
Views: 8,625
Posted By Agentorange
Re: Oil changes, I think I am going to start doing it on my own

Just drain the oil in to a pan because the pumps don't get it all out.

When removing the filter, use regular Aluminum Foil and fold it to about 12"x12" square. Mold it around the area behind the oil...
Forum: Technical Discussion and Customizing your H2 09-28-2010, 07:05 AM
Replies: 21
Views: 16,256
Posted By Agentorange
Re: Exhaust manifold bolt breaking?

Been on for 1-1/2 months now and all is well. Yes got them on Ebay.
AO
Forum: Technical Discussion and Customizing your H2 08-13-2010, 01:24 AM
Replies: 21
Views: 16,256
Posted By Agentorange
Re: Exhaust manifold bolt breaking?

I had 2 broken on the right side and 2 broken on the left. The left rear was broken below the surface and it took me a few hours to drill it out and extract it. The other 3 had exposed studs that i...
Forum: Technical Discussion and Customizing your H2 02-26-2009, 09:26 PM
Replies: 13
Views: 3,342
Posted By Agentorange
Re: Anyone want to help an idiot?

Yes you do need the Diode. It allows the voltage from the headlight relay to pass thru it and power the running lights, but not allow power to go the other way. Without the diode, the voltage can...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT +1. The time now is 08:52 AM.


Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.