Hummer Forums by Elcova  
Forums - Home
Source Decals

Source Motors
Custom. Accessories.

H2 Accessories
H3 Accessories
Other Vehicles

H2 Source

H2 Member Photos
H2 Owners Map
H2 Classifieds
H2 Photo Gallery
SUT Photo Gallery
H2 Details

H2 Club

Chapters
Application

H3 Source

H3 Member Photos
H3 Classifieds
H3 Photo Gallery
H3 Owners Map
H3 Details
H3T Concept

H1 Source

H1 Member Photos
H1 Classifieds
H1 Photo Gallery
H1 Details

General Info

Hummer Dealers
Contact
Advertise

Sponsored Ads










 


Source Motors - custom. accessories.


Go Back   Hummer Forums by Elcova > Search Forums

Showing results 1 to 25 of 170
Search took 0.01 seconds.
Search: Posts Made By: pdsq99f4
Forum: Technical Discussion and Customizing your H2 12-04-2010, 11:10 PM
Replies: 6
Views: 2,006
Posted By pdsq99f4
Re: OnStar Backup Battery 2004 H2

I'm pretty sure your h2 doesn't even have a backup battery. Take it to the dealership to have the code scanned.
Forum: Technical Discussion and Customizing your H2 07-20-2010, 05:23 PM
Replies: 11
Views: 5,124
Posted By pdsq99f4
Re: need help with climate control on H2

To save yourself some money, I would just have them replace the mode actuator and not the inlet actuator. The inlet actuator will just cause the recirculate to not work. That is the one that the dash...
Forum: Technical Discussion and Customizing your H2 07-14-2010, 05:24 PM
Replies: 3
Views: 685
Posted By pdsq99f4
Re: Trailer Electrical gremlin

The LTTRLR and RTTRLR fuses are in the IP fuse block on the left side of the dash.
Forum: General H2 Discussion 06-16-2010, 09:48 PM
Replies: 14
Views: 1,930
Posted By pdsq99f4
Re: Recall - Heated Windshield Washer Fluid

The vehicle's harness doesn't even get cut. It's the wires that are part of the heater. There is no "major surgery" the wires are just cut and taped so the connector isn't left unplugged to get...
Forum: General H2 Discussion 06-16-2010, 09:45 PM
Replies: 5
Views: 980
Posted By pdsq99f4
Re: Am I Too Paranoid?

You're not too paranoid. You're smart. A lot of aftermarket people don't correctly connect aftermarket stuff and you could be left with a rat's nest of wiring that kills batteries.
Forum: Technical Discussion and Customizing your H2 06-14-2010, 02:16 PM
Replies: 7
Views: 1,913
Posted By pdsq99f4
Re: Single Stage Air Compressor to Dual Stage

The only line you really need is the inlet line. It has two inlets instead of one on the old system since it has two compressors. You just remove the old inlet
line and put the new one in it's place.
Forum: Technical Discussion and Customizing your H3 06-10-2010, 09:43 PM
Replies: 5
Views: 1,531
Posted By pdsq99f4
Re: Exhaust Headers & Catylatic Converter

I'd be warry about the rear exhaust manifold to head bolt breaking off in the cylinder head. It may already be broken. You can reach back behind the heat shield and feel for it to see if it is. It's...
Forum: Technical Discussion and Customizing your H2 06-10-2010, 04:58 PM
Replies: 2
Views: 761
Posted By pdsq99f4
Re: Hummer Computer

Sounds like the computer wasn't really flashed back to stock. I've flashed it back to stock before and then used a programmer and it worked fine.
Forum: General H3 Discussion 05-21-2010, 04:10 PM
Replies: 6
Views: 1,215
Posted By pdsq99f4
Re: WIll running boards from a H3 fit on an H3T

No they'e different. The H3T boards are longer.
Forum: Technical Discussion and Customizing your H2 05-21-2010, 03:58 PM
Replies: 3
Views: 700
Posted By pdsq99f4
Re: Keyless Entry

Actually the H2's use the passenger door module as the keyless entry reciever. What problem are you having?
Forum: Technical Discussion and Customizing your H3 05-13-2010, 06:39 PM
Replies: 18
Views: 12,207
Posted By pdsq99f4
Re: Trouble filling H3 gas tank.

It may be your evap vent valve is glogged. Do either of you live on a gravel road by any chance? That gravel dust will clog a vent valve after time.
Forum: Technical Discussion and Customizing your H2 04-27-2010, 05:31 PM
Replies: 8
Views: 935
Posted By pdsq99f4
Re: which one?

If you have air suspension, be careful with the Magnaflow. I installed a dual tip system and it came so close to the right air spring, it melted a hole in it. I had to make a heat shield to go around...
Forum: Technical Discussion and Customizing your H2 04-16-2010, 11:13 PM
Replies: 6
Views: 790
Posted By pdsq99f4
Re: Sqeeeling brakes

42K and you changed the pads? Why? These pads go to around 100K.
Forum: Technical Discussion and Customizing your H3 04-16-2010, 11:09 PM
Replies: 5
Views: 3,273
Posted By pdsq99f4
Re: H3 Towing & trans cooling

H3's have only the typical trans cooler in the radiator. You can always add an aftermarket one if you want. The 5 cylinder may have to work pretty hard to tow something that heavy though. They're not...
Forum: Technical Discussion and Customizing your H3 03-12-2010, 10:33 PM
Replies: 3
Views: 1,007
Posted By pdsq99f4
Re: Need Hepl Please!

Have you tried a new battery?
Forum: Technical Discussion and Customizing your H2 03-12-2010, 10:26 PM
Replies: 1
Views: 634
Posted By pdsq99f4
Re: Air Suspension has to go...

Fabtech has their own springs that are longer and lift the vehicle up. You just have to take off the spacers and put in an insulator on the bottom spring perch.
Forum: Technical Discussion and Customizing your H2 03-08-2010, 03:04 PM
Replies: 3
Views: 642
Posted By pdsq99f4
Re: HVAC HELP !! any techs on this forum??

Maybee there is a different program in the new control head. The dealer could check to see if there is an updated program of codes in the controler. I don't think I would go in with an attitude...
Forum: Technical Discussion and Customizing your H2 03-08-2010, 03:00 PM
Replies: 10
Views: 1,113
Posted By pdsq99f4
Re: Diff leakage :(

Exactly. It's a terrible idea and you would be rebuilding your t-case very soon.
Forum: Technical Discussion and Customizing your H2 03-04-2010, 10:17 PM
Replies: 10
Views: 1,113
Posted By pdsq99f4
Re: Diff leakage :(

If you have the ability, take it out and reseal the case halves. We do it all of the time on these older h2's. Use anerobic sealer, not silicone. Replace both axle seals while you have it out. Should...
Forum: Technical Discussion and Customizing your H2 02-22-2010, 11:05 PM
Replies: 7
Views: 3,409
Posted By pdsq99f4
Re: showing a DTC P0446

If there is a lot of snow where you are from, the vent solenoid could also be clogged with snow under the driver's rocker panel.
Forum: Technical Discussion and Customizing your H3 02-22-2010, 11:00 PM
Replies: 6
Views: 10,865
Posted By pdsq99f4
Re: H3 engine turns but won't start.

The remote start is most likely at fault here. There is a bypass module for the remote start system that is not "tricking" the anti-theft propperly. I would have them remove the remote start and ask...
Forum: Technical Discussion and Customizing your H3 02-19-2010, 02:56 PM
Replies: 2
Views: 1,203
Posted By pdsq99f4
Re: Help on Navigation radio installation

Two things:

1) I don't think it's possible since the radio will be locked when you put it into another vehicle. The methods for unlocking an H2 radio and an H3 radio are totally different and I...
Forum: Technical Discussion and Customizing your H2 10-27-2009, 05:01 PM
Replies: 14
Views: 3,847
Posted By pdsq99f4
Re: Calibrating Air Suspension....

Just use a jack or something to put the suspension at the ride height you want and hit the button on the techII. The ride height sensors do need to be around 2.5V though.
Forum: General H2 Discussion 09-11-2009, 09:56 PM
Replies: 5
Views: 969
Posted By pdsq99f4
Re: Engine problem

I had an underhood fuse block cause the same concern. It was shorting on the ignition 1 relay.
Forum: General H2 Discussion 09-11-2009, 09:51 PM
Replies: 1
Views: 822
Posted By pdsq99f4
Re: Magic bullet

Looking at their claims, I would stay away. They obviously know nothing about a pcm tune. I tune for a living and have never gotten 50+ hp from a stock truck motor. Let alone, they are claiming that...
Showing results 1 to 25 of 170

 
Forum Jump

All times are GMT +1. The time now is 10:18 PM.


Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.