Well I haven't looked at it that closely. When I did mine I didn't want to remove the factory base. The shifter I made slides over the factory 1/2". There is a 1/4" plastic shaft that goes in the middle of the 1/2" rod. I had to gut out the inside of the "T" handle so I could make a mechanism to work inside the shifter. The shifter you want is a little simpler to make because your button doesn't have to be 90 degrees. I would need the Hurst shifter to modify. Only need the shifter itself. I wouldn't use the base or hardware at all. I don't know if you can just buy the handle. I charge $75.00/hr. and I am sure it would be a days job. I would fit everything to my H2 and take photos before I would ship.
Let me know what you want to do. There is a small allen head set screw on the shaft of the factory shifter if you want to remove it and take a look or I can take mine off and send you photos.
|