Interior doors panels are held in place by pressure clips. Start at the bottom by placing a thin straight screwdrive between the panel and the door frame. Slide the screwdriver up into the panel and then slide the screwdriver left or right, it does matter which way. The screwdriver will run into a clip. Stick another thin screwdriver up insidethe panel on the otherside of the clip. Now pry both screwdrivers up and the clip will pop. Keep doing this along the bottom and sides of the panel. There is a screw by the door handel. After the panel is loose the top will slide straight up. The top of the panel is hooked to the top of the door frame. You then unplug all the electrical connections.
I have not taken my door panels off yet, but have taken many other panels off of other cars. I wnet to the garage and took a cursory look at the door panel. It looks like there might be a small panel on the door panel around the door handel. If you look at the back edge (opposite of the end that the screw is in) of this small panel, it looks like there is a pry indentation built into the door panel.
|