Poron comes in two models. I got the Micro 3 with Voice Distance Indicator (VDI).
More info on the Micro 3 here
There's also the Mini 3 with LED display.
More info on the Mini 3 here
Here's where I mounted the speaker, sensor and module respectively.
There's a predrilled hole in the rear right light housing. If you look underneath the right rear bumper under the right lights, you'll see a 1/2" hole which leads up to the inside of the rear right cavity. Inside the cavity is covered by insulation. Just run the wires under the rear bumper and up through the right housing.
I used wire looms to protect the wires underneath the bumper and also give it that OEM look as there are a couple of other wire looms under there already.
The speaker was just as easy. You'll see how to run the speaker wire when you look inside the cavity.
The tricky part was knowing how to remove the rear light housing. First remove the two star bolts. There are two clips on the outer side of the light housing and the only way to complete remove the housing is to slide the housing towards the center.
Regards,
David
----------
H2SUT.com
----------
Red metallic, Lux package, Poron backup sensors, Independent dual DVDs, Volant air box, DRL mod, SMA chrome hood handles and latch.
[This message was edited by NSXTC on January 25, 2003 at 01:24 AM.]