The winch is ready to test and respool. Run the new line UNDER the spool and attach to the ground screw. Turn the winch mounted dial 180*.
Have someone run the winch while you pull the line and run it across the spool keeping it taught.
When finished you can begin mounting the valance. You only use four of the original screws and you may want to trim the bottom of the valance above the winch to completely clear it. I started to do this, but screwed up so I just jammed it on and it works fine.
__________________
"My reading of history convinces me that most bad government results from too much government."---Thomas Jefferson
|