Brads link made me laugh again. I was into the first full hour of getting my hook mounts off with instructions I got with my Aries brushguard. Jeeze not good. I think Aries was Farkin with me. I ended up drilling them out, and filling the holes with alittle black silicone. Its just a retainer clip on a small 1/4 inch stud holding the bracket on. If you wiggle the bracket till it rotates freely you can pop the retainer clip off and your in business. Use a pry bar and towel to protect your bumper. It will snap off fairly easy. This stud is really of no use other than holding the mount on during assembly at the plant. After I drilled I saw how easy it would of been to just twist and snap, but I didnt know that at the time. Its up to you if you want to take front end parts off,,,Brads link was alittle over the top for this issue, It can be done without taking the whole front end off. Hope this helps,,,, See ya
|