Running the cable is SOOO EASY you are going to be shocked!
Get under the dash and look above the gas pedal. There is a square of sheet metal (mine's white and I think it is matched to your body coler -the truck, not you). The square measures about 4" x 4".
Pick up a drill and pur a 1/2 or larger hol through it. (Mine needed a 5/8 for the cable).
Run cable through hole, fuse, and grommet or seal with silicon glue (or both).
Get the fuse at an RV dealer (150A) and pay 1/3 the cost of the same fuse at a marine store.
Next pull out the door sill trim from both doors on the driver side. Run the cable under the fron edge of the carpet to the door sill, through the door sill, under the b-piller (use coat hanger and tape to snake, under door sill, and then to where you mounted the inverter under the back seat.
Leave message if you need to know how to mount the inverter.
I also installed battery terminal covers over my terminal lugs on the back of the inverter to avoid "surprise" contact with the hot lead.
Great questions... keep um coming...
__________________
\"I\'ll worry about the splinter in my eye when you worry about the plank in your\'s\"
2 Pissed off dealer mechanics, Origami frame, Convex UCP, 2 Bent cross members, Dented driveshaft, Broken sway bar mounts, misaligned transmission, exhaust leak, Pl
|