View Single Post
  #2  
Old 12-19-2005, 10:54 PM
KenP's Avatar
KenP KenP is offline
Hummer Messiah
 
Join Date: Apr 2003
Location: Virginia Beach
Posts: 37,474
KenP is an unknown quantity at this point
Default

Thanks PhilD for the removeable steps. These are a royal PITA to install. I'm not kidding.

Start by removing the factory running boards because they're going to get bent up and rust anyway. There's 8 nuts and bolts. Start on the outside and work to the center. Piece of cake.

Now for the difficult part, installing the removeable steps. Sit on the ground. Hold step and line up alignment bungs to holes under rock rail and slide on. I said, "align the bungs... ALIGN THE BUNGS!"

Ok, so that's the real problem, aligning those damn things did take a few minutes.

Run the bolt through after aligning the bungs and holes, screw bolt in and insert cotter pin.

I only installed two because I got tired of f**king with it and it was cold.

P.S. I just wanted to say "bung" and "hole" in the same sentence.

Thanks again, Phil.
__________________
"My reading of history convinces me that most bad government results from too much government."---Thomas Jefferson
Reply With Quote