[timgco]

Ok, this isn't too bad. I just did this project this week.


Go to Autozone and get a add-a-fuse. Open your hood and look into your fuse box. You can use the #17 slot (this will allow you to only use the lights with the truck in the run position or with the truck started only). This way you won't kill your battery by leaving them on by accident

Don't plug the fuse in until you are all the way done. You can run the wire into your cab through the firewall or go in through the drsd boot wher all your door controld come into. Just pull that boot out(it's tough) and than punch a hole through it. Make sure to seal it up when your done.

I mounted the PIAA 20 relay with 3M tap to the panel in the back of the engine bay. You have to remove the bracket. The ground cable for that realy can be run next to it with that ground bolt.

I mounted the switches in the wrong spot. I wanted them on the RH side of the steering wheel but ran th ewirer too short. If you put your switches where I did, you will have to grind out some of the dash. You won't see it though when you put the panels bacck in. i also cut off the PIAA switches. I use Hella ones. I prefer the look of them better and they arer flush mount.

here's some pics. I hope this helps.
The first pic you can see the boot I ran the wires through and the Hella switches.