<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by baskethead:
How did you run the wiring for the lights and do you notice much of an increase in wind noise?
Thanks
Greg </div></BLOCKQUOTE>
Wind noise isn't too bad. to run the wires you pop off the outside A Pillar moldings, air vents on either side of your hood and run the wires down the A Pillars to the engine bay over to your battery. The switches come in through the sidewall boot on the DR SD and run under your dash to wherever you mount the switches. the first H3 rack I wired was my sig. others and it took about five hours. Next one can be done in around 3 1/2. It's more or less just taking your time to neatly tuck wires and anchoring them. This was much easier than running wires for the H2 racks. The rear lights are pre-wored in the rack and stick out the front already, so you run those down the same way. Feel free to PM me with any specific Q's.
tim.
__________________
TAIL RATED!
|