i do not have crancked the stabilizer bar (not the torsion). My H2 on the point that i have marked measure 101-3 cm not and i think that is about 2 cm. less than the highest point of the wheel arch. and now is ok.
But if you turn the screw under the body you can lift ... only the body.
I have installed the Rubberduck tie rods. they are great but after i have installed also the edelbrock shock xtreme with reservoir. something have changed something. now if I lift the two front wheels I can not turn the wheels because the inner part of tie rods touch the torsion bar... what is the solution..
Z height ... where I can measure ? and what is the measure ?
|