Ok, here is the info on the keyless entry feedback.
1) With the engine off, turn the key to LOCK. Do not remove the key from the ignition.
2) Press and hold the lock and unlock buttons on the remote keyless entry transmitter at the same time. Hold both buttons until the DIC display shows the current remote keyless entry feedback mode.
3) To view the next available mote, press and hold the reset stem for approximately two seconds. Release the reset stem and press and hold again to view each mode.
4) Once the desired mode is shown on the DIC display, briefly press the reset stem to set your choice. The DIC display will then clear.
good luck.
