<BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR>Originally posted by PhilD:
I installed the Vizualogic monitors and used a straightened out coat hanger to feed the wire from the headrest hole down to the bottom corner of the seat. No need to take anything off or apart. To be on the safe side I folded the end of the neger over and covered it in tape, to prevent accidentally damaging the vinyl seat covers.<HR></BLOCKQUOTE>
PhilD,
How did you remove headrests? I picked up the neoprene seat covers which has holes that the headrest "poles" fit into. Any help would be greatly appreciated!
Regards,
RasterMaster
Check out the OkC Chapter Page!
|