[Beastmaster]

In Arizona, there is a chain of car wash joints called "Danny's Family Car Wash". They all have service bays.

One of their oil/lube/filter specials is $29.99 for a diesel (using Shell Rotella T), with 2 gallons of oil, plus filter and grease.

As for knowing the vehicle - I agree it's worth knowing where all the points are and how to do an oil change. I recommend doing it at least once. However, the cost involved in the oil change isn't worth it for me in the long run.

For my cost, it's 16 bucks for the oil (2 gallons), an average of 10 bucks for a filter, and 3 bucks for synthetic grease for the grease gun. Add the time to go back to a parts store to recycle the oil, and I'm out money.

As for grease points - the owners manual kinda sucks when giving good locations on the actual zerk placement.

To help list them, they are:
4 Upper Ball Joints (top of A-Arm)
4 Lower Ball Joints (Found behind a CTIS dust shield - You need to jack the truck up to ensure grease gets in the ball joint - the weight of the truck will not allow grease to get into the bottom of the ball joint cup)
4 Front Tie Rod Ends
2 Idler Arm
1 Pitman Arm
3 Steering Shaft joints (2 U joints, 1 slip)
5 front drive shaft (3 U joints, 2 slip)
2 rear drive shaft (2 U joints)
2 Radius rod ends

If you have a tire carrier, fuel can carrier, and/or the pintle hook tow attachment, each of those also has a grease gun point.

I grease each of these points before and after an off road run to ensure that the parts in question don't wear too much.

So - for $29.99 and a printout of the above, you can have some quickie lube do all the labor for you. Admittedly, the grease points takes me all of 15 minutes to hit every one of them....so it's not too time intensive at all.

-Steve