<UL TYPE=SQUARE>Service VME - Cannot Remove Ignition Key - kw console cylinder lock shift control open solenoid wire #PI01782 - (Feb 24, 2004)
Service VME - Cannot Remove Ignition Key
.
When servicing the vehicle with the VIN you entered, the following diagnosis might be helpful if the vehicle exhibits the described symptoms.
SERVICE VME
If you encounter a situation where the ignition key cannot be removed from the lock cylinder, the most probable cause is a broken wire or harness disconnect at the automatic transmission shift lock control solenoid located under the shift plate on the console. Simply correct the open circuit condition and provide enough slack in the harness to allow for full travel of the shift lever without placing any tension on the harness.
.
Please follow this diagnosis process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed. If these steps do not resolve the condition, please contact GM TAC for further diagnostic assistance. This diagnostic approach was developed for the vehicle with the VIN you entered and should not be automatically be used for other vehicles with similar symptoms.
Models:
(03, 04 HUMMER H2)
[/list]This is a possibility. There was some sort of "recall" on this problem now that I remember from looking back. Several people have had to have their ignitions replaced and this was a know problem and Hummer should cover it even if you are out of warranty, in my opinion.
|