I've been using the pre-cut shields for about 9 months now. They have been working great. Unfortunately there are some deep gouges on the hood and where the shields don't cover on the doors.
Some Experiences:
Putting the shields on in colder weather is easier, but they have a good chance of ripping on you (brittle), especially during removal. Putting the shields on in warm weather is a PITA (malleable) and requires extra patience.
I find it best if the shields are kept flat at all times. If you curl them up and it isn't warm enough, you will have great difficulty getting them to stick properly. If you fold them, the same applies with the addition of possible cracks/rips/tears.
Taping the front edges of the front doors is also a PITA. I'm currently experiencing sticky doors from tape residue. Still haven't found the perfect gunk remover.
Oh, I also don't bother using the little trim pieces on the very bottom of the doors. They just seem to get ripped off so easily. I've had many rips and tears in the big pieces and have to piecemeal them back on the truck like a puzzle.
|