<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by H2Finally:
I was wondering the same!
Would there be a prob with finding the "wire" which passes the signal to cycle both mirrors? Since this is achieved only when the L/R switch is in the middle, it seemed likely that this is a "programmed" signal, rather than a dedicated "wire". </div></BLOCKQUOTE>That's what I am wondering. But the BCM has to get a signal from something to send current to the wire going to the motors on the mirrors.
I would say you could tap that circuit but who knows where the temp power signals that allow it to cycle on/off is controlled. I am worried that is BCM controlled and if there is a wire at the mirror controls, one wouldn't have to worry about that.
|