The unit on top of the case is a plastic car caddy that is secured with two screws in the base. We drilled two holes in the top of the case, one of which was slightly off-center due to the construction of the unit?s compartments.
After removing the plastic faceplates on the drive bays, we measured the inside dimensions of the drive bay space and cut a block of Styrofoam to fit snugly inside. From this block of foam, we hollowed out a space that would accommodate the fake pussy. The fake pussy we chose for this project is
Jesse Jane?s Intimate Passages. This unit is made from soft, fleshlike Cyberskin material and has two internal passages, vaginal and anal. It also comes with a removable battery-powered bullet vibrator. We chose this model of fake pussy because its size and squarish dimensions coincided nicely with those of a standard PC drive bay. Since the fake vagina and ass takes up the entirety of the drive bay space, it will be necessary to install an external drive, but this is a small price to pay for having a premium pussy in your case.
After cutting the pussy compartment into the foam, we cut a hole in the back of the foam, both to provide a space to accommodate deeper thrusting, and to thread through the control unit and wires for the vibrator. We covered the foam with black duct tape, both for protection and for appearance. After inserting the pussy in the foam block, with the vibrator wires and control unit extended through the back hole, we positioned the unit in the drive bay. At this point the vibrator controller was on the inside of the case.
We decided to bring the vibrator controller out through the front of the case, through the 3.5? drive bays. In order to do so, we had to file a small notch in one of the face plates to accommodate the wires. After replacing the face plates, the wires were securely positioned, and we added an adhesive cable keeper on the left side of the case to keep the controller out of the way until needed and keep the wires from getting tangled.