Quote:
Originally Posted by f5fstop
When you say 'looped' the two purple wires, you did leave them connected to the connector as well, and connected a wire between the two purple wires.
I just installed a double wire splice in between them.
Mute output wire from the radio, you did connect that to the cut brown wire that goes to terminal 18 of the PAC adapter? Not sure what would happen if connected to the other terminal of the cut wire.
Left the mute wire from radio disconnected, do I need to splice this in??
Red from radio is connected to pin 30 of the relay? This gives you the ignition On input that is normally supplied by the BCM to the factory radio.
Yep, getting power just fine now, nav works but no sound.
Need coffe to think....
|
Yes need more coffee.....coffee is good....