Quote:
Originally posted by MxHonda:
What is the pic of that gave you more bottom end response?
|
I installed throttle body spacer. Forgot to show it installed. beware tougher than instructions. This is not a Colorado and instructions do not adress h3 aplication. Remove all 4 inch ducts. Then remove abs plenum ( two bolts on r side ) Make shure to place new gasket on oposite side of factory green gasket so that there is a gasket on both sides of spacer. Finally make shure to reinstall small hose on bottom of abs plenum befor reinstalling the ducts. P.S. This may be a little difficult due to the new throttle bod spacer. I solved this by applying a small dab of vasoline on male end of ducts to allow them to slide in easier. Dont laugh it worked.