Quote:
|
Originally Posted by SR1355
Go to install first rail again get five of six bolts in but there is no way top front bolt is going in. It's aleast 1/8" off. On to other side and same problem, but a few other as well. This is driver side with emergency brake cable on frame rail. The rock rail was notched at first support for cable but not enough, at second support no notch so it deflects cable at bit, and a third support you have to unbolt brake cable support and remove to move cable out of way with no way to rebolt. This leaves cable flopping around with enough slack to end up in rear wheel. I can take care of this but that's not the point. Poor design, poor service, powder coat could be better, it will get scrached but that again is not the point.
They are installed now and look great. I'm sure they are well built and will take anything I can throw at them but they need to work on a few things for me to recommend them. I'll post pics later.
|
How did you get the install finished if the bolt holes were off? I had similar problems. Wrong bolts, holes not lining up and bad design around the parking brake cable. I sent mine back.