Squirrel stew is pretty good with the right spices.
Better hope it is the main engine harness and not the body harness. The engine harness is hard to install, a lot of precise routing around the engine and to the trans, but the body harness is a downright pain in the rear.
It runs all the way from the BCM in the right front kick panel, under the I/P, through the grommet to the engine compartment all the way to the front left to the junction block and forward lamp harness. It probably requires removing the I/P or at least major components and trim panels.
I would guess the part is about 800 bucks (I might be low on that figure) and install will easily take two-days to do the install correctly. Engine harness would take about six hours.