DRTYFN: Well let me explain where the $$ went & the time. To start off with every planstic piece on the interior and exterior except 3 has been sanded (detexturized) and colour matched or wrapped in suede. All the colour matched pcs were also treated with 3M tape. This is so they don't scratch when you use the truck as well when the truck is driving and the panels rub together. The original bumpers were smoothed out and Chromed. This is an enormous cost and very time consuming because since they are stamped pcs they warp when heated. This would distort the chrome, so you have to then smooth the bumper back out. Now when you look there is no tow hooks or winch reciever in the front. This was countless man hours. The back was the same way. The Passenger side grab handle on the dash was about $4500 to design and CNC. This is not a store bought pc. That took alot of fine tuning to get it to mate right to the dash without looking hack. Nobody we could find made an after maket pc to replace the factory handle there probably because of the level of difficulty. I thought it might have been because of the airbag but after checking with the dealer as to how the bag opens this was not the case. There is so much attn to detail on this truck it is crazy. The whole thing was sound deadened with dyno-mat. The TV's, the subs, the back up sensors, tinted LED taillights, train horn, etc. All I initially listed for MODS was the major things. We also did all the little things that almost every Hummer guy up here does.
Also regarding the $$$ keep in mind all the bolt-ons came from the US so we have exchange on it, duties, brokerage, the shop's tax and then the 15% goverment tax. So if this was done in the US the cost would have been probably around $85K USD.
And finally YES it was our 1st Hummer. Usually we work on the exotic sports cars and Bling them out. Does this Hummer have to much chrome, on the inside I agree (but do what the customer wants), on the outside I don't agree. I think the customer stopped just before going overboard.
RazM: No the truck has never been to Kingston. Since I don't own the truck the way I know is that the truck doen't have those webbed trussets (roof rail supports) on it. They are more conservative with plain round holes.
obzidian: The rims are 24in DUB Big Homie 8s and they have 15 offset. The tires are Kuhmo Road Venture MT KL71 37/14/24. You can check our when site
www.esscustoms.com for contact info. and call us for the 3D indicators. Ask for Dave!