Re: Rear Tire License Plate Holder Question!
There are three parts you are missing. The wiring, which as you say runs along the outside of the backside of the whole assembly; the bulb assembly; and the lens. The lens fits into the cylinder end (rear-most) and the bulb assembly screws into the same assembly.
I can send you pictures of everything if you like. I ended up leaving the full length of the wiring, just in case I needed to go back, but I still have all the parts I took off.
If you can't find the parts, I'll give the stuff I have to you. It will probably just sit next to my stock H2 rims, and side vents, and the stock intake, carb, and exhaust I took off my '68 mustang 20 years ago...
__________________
2006 Twilight Maroon H2, Procomp 6001 rims, 35" X 12.5 X 17 Xterrain tires, Ram over-the-hood brush guard, Jet Stage I, Warn 9.5 winch and winch bumper, Hedman Headers, K&N Air charger, Lightforce driving lights, a little CHROME for good measure
2006 Victory Red H3 (The Titanic), R.I.P. - It didn't float
1968 Mustang GT convertible
2005 Harley Davidson Hertitage Softail, Stage I, Vance and Hines Big Shot Longs - Sold 
2004 Jaguar S-Type (the wifemobile)
|