View Single Post
  #10  
Old 03-22-2007, 01:02 PM
CrisB's Avatar
CrisB CrisB is offline
Hummer Professional
 
Join Date: May 2006
Location: Michigan (non-PIKER)
Posts: 414
CrisB is an unknown quantity at this point
Default Re: Hunner's Skids Install made simple

Nope, it's not all flat, frame is overlapped there...hold them in place with a magnet & weld tight to where it is touching, then build up around it some. Also weld down outer frame edge. I didn't bother welding on fuel tank skid side, they are held on nice & tight with just those two edges. Plate will extend a little further outside frame (not quite centered), just line up straight & go. That frame is some hard steel, turn up the voltage!

Great call on the ratchet strap idea, it holds the shock compressed so everything stays together, thanks!
__________________
2006 H3 Adventure, green in & out, Line-X, no bling. Onboard air, Rino GPS, BVG roof rack, roof-mounted lights, Warn xd9000i winch, RR rails, Hunner's skid plates, custom UCP, rear tire rack, roofcam.

1965 IH Scout 80, fully restored with winch, lockers, Dana 44's...holds it's own to an H3.
Reply With Quote