Re: Hunner's Skids Install made simple
[quote=Cris Burkhalter]Nope, it's not all flat, frame is overlapped there...hold them in place with a magnet & weld tight to where it is touching, then build up around it some. Also weld down outer frame edge. I didn't bother welding on fuel tank skid side, they are held on nice & tight with just those two edges. Plate will extend a little further outside frame (not quite centered), just line up straight & go. That frame is some hard steel, turn up the voltage!
Hunner, that's me wrote
yeah what he said! TIG would really work better with the frame butt if a frog had wings...........you didn't get any of that splatter on ye didja??
__________________
Traded 06 I-5 for 08H3 ALPHA/Adv,WarnPowerPlant9500,Warn 9000ti rear,Steelcraft brush/winch mt,RockyRoadrails/Hunner mod,GMUCP,Hunner rear/shock skids,OEM roof lights,Rola rack,2GoLights,Hunner steering gear mount,Purple Cranium diff guard,BulletProof tie rods,ARBsnorkle, SyKlone prefilter,Hunner intake pipe.
Last edited by Hunner : 03-23-2007 at 03:54 AM.
|