[hummer_metal]

What??? 1600 lb pull & the bumper bent? Doesn't sound right....mine has handled some extreme pulls with no problems, until I really put a full load on it at a low angle.

Who said the bumper bent Cris?

I didn't say that, did I???????????

Nothing was bent, I stopped the pull before damage was done. I noted what was going on... Nothing more, nothing less.

This is what I said, note that I have not REVISED what I am sharing...

Cris I had a chance to use the winch deck today, looks good, no doubt.

But as you mentioned, there is a problem with the pull. I thought the front end of my rig was going to pull off.

My brush guard tweaked down towards the winch deck, and the front of my rig was bent. I stopped the pull because my whole front end was looking bad.

Under a load of 1600lbs I didn't expect it to act like this.

I didn't, so I shared with you what was going on with the winch deck. I paid for it, and used it, and am giving you feedback on its use in the field.