Re: H2 Snorkel
DRTY is right you cannot pull air through the fender system very easily in that location. You can relocate washer tank then cut hole that will go to engine bay.
You can use the caps to add screens in front. Make a rubber seal so that when you pop cap on you get a ram air type system once you also make a new intake tube to air filter. With supercharger not really looking for ram air but, coolest air. This is a MOD Dragon and i have already figured on doing next. Just rough look and drawing as we are not there yet. Still need to figure a rain drain into the system like a small U in the line before filter with a drain in it. Do not want to disrupt air flow to much so not sure how we will do the drain yet may just take air from a dry location up top. Plus my Mall Queen does not see ugly weather anyway though you never know when you may get caught off guard. Will not be to hard to figure it all out but, will retain the stock look. Any suggestions welcomed though. Thanks for sure for those!!
It would not be a great snorkle unit but, air intake would be up a little higher. Most likely higher than someone would want to ford water that deep I guess.
Well anyway just a thought.
TAZ
__________________
05 H2 SUV cus. paint, Magnuson SC 6/12lb boost, cowl hood scoop, 12" dash touchscreen, GM elec. fans, HPTuners.com tuning soft., Dynatech headers dual catback exhaust Jet Hot chrome front to back Flowmaster Super 40's, Diamo 8 Karat rims & 325X60-20" Toyo, 4 OEM Captain seats Katzkins leather, rear console computer inside running all AV/NAV etc., Infinity component system 3 amps Tsunami Caps, rear flip down 12" monitor, headrest monitors, overhead console boost, fuel pressure, & A/F ratio gauges
|