[6pack]

I got out to look at it in more detail. The boot is pressed into the center console. Pull up on the back of the trim piece that surronds the bottom of the boot and the rear slots pop out. Then pull the whole boot to the rear and the front slots pop out. Then lift the whole boot up and over the shift knob. There is a rubber o-ring that holds the boot into a slot and secures it just below the shifter knob. Pry the o-ring out and the boot comes loose and you can slide the boot down the shifter shaft. From this point though, I see no way to get the shifter knob off. There is no noticeable allen key or anything holding it onto the shaft. If I pop the top trim piece like Wisha says, there is a metal piece there with a slot in it, but it is very shallow. I don't believe this is meant to put a screwdriver in. It looks like the shifter handle is just pressed down onto the shaft. I tried twisting and pulling on it but it's not budging. Any suggestions?